Windows server 2008 r2 initialize disk incorrect function

All being well the drive status will change to Regenerating as the data is rebuilt using the parity information on the other drives in the array. If, once regeneration is complete, the status does not return to Healthy, right click once again and select Regenerate Parity.

If this fails the disk may be unrecoverable and will need to be replaced. To achieve this, right click on the volume on the failed disk and select Remove Volume from the popup menu.

Once the volume has been removed, right click on a suitable block of unallocated space on another dynamic disk which is not already part of the RAID 5 array, has sufficient space and has a matching partition style and select Repair Volume.

This will rebuild the RAID 5 configuration using the space on new disk drive together with the remaining healthy disks from the original RAID 5 configuration. Jump to: navigation , search. Navigation menu Personal tools.

Namespaces Page Discussion. Views Read View source View history. This page was last modified on 27 October , at Copyright Payload Media, Inc. All Rights Reserved. And you may receive different error message in the following:. The issue occurs because the folders or libraries that you are trying to back up or restore include a reparse point. If the reparse point points to a volume that uses the FAT file system, it will cause this issue. A file or directory can contain a reparse point, which is a collection of user-defined data.

A reparse point may be used to point to a file that is temporarily relocated on a different drive. Windows Backup sometimes fails to read the last sector on the volume. You may receive windows server backup error incorrect function if the last sector is corrupted. In the following, you will learn 4 fixes to Windows Server Backup error incorrect function, namely, remove the reparrse point from library, shrink volume with disk management, use shorter backup path, or different backup path to tore backup images.

For details, please check them below. To deal with Windows Server Backup completed with warnings incorrect function caused by reparse point, you should remove the reparse point from the library, and then create a backup again. First, you should know where the reparse point folder is. To locate reparse point folder or its subfolder, do as the following. Note: You see several entries that say "junction" and the location to that the entries point. Junction point is another name for reparse point.

When a program tries to write to a directory that is really a reparse point, those files are sent completely blindly to the other directory instead. After you find reparse point, delete it. To delete mounted volume reparse point, follow these steps. In the General tab, confirm the folder Type is Mounted Volume and then delete this folder. That's very strange behaviour; I've certainly never seen that before. Do you have another server to try it on? To the best of my knowledge there is no 'secret sauce' involved, just plain old disk manager.

I'm getting all these "path failure" events in the System portion of Event Viewer. Usually two path failure notifications, then a Controller Failure notice, and finally: "VDS fails to write boot code on a disk during clean operation. The 2TB issue is making me think there's a bit driver in the mix somewhere One source of problems in general could be an incorrect MPIO setup.

GPT itself is nothing special, right, "initializing GPT" just means writing a few blocks to the block device? We want to say Yes to both of these! Once both prompts have been accepted it will format the drive, it uses a quick format so it doesn't take too long.. And then if all was successful we are taken back to the command prompt and it should look like this If you take note of the Label it says, we can verify it was added to WSB by checking for that Label.

And there we have it, another drive successfully added to WSB! Labels: directory name , or volume label syntax is incorrect WSB windows server backup r2 , The filename.